kernel-fxtec-pro1x/drivers/isdn/hisax/nj_s.c
Jeff Garzik 8349304d12 [ISDN] Hisax: eliminate many unnecessary references to CardType[]
For the vast majority of CardType[card->typ] uses (but not all!),
the string is constant for each driver.  Therefore, we may replace
CardType[card->typ] with the actual string describing the driver, making
each printk() a bit more simple.

This also has the nice, intended side effect of greatly reducing
external references to hisax global CardType[].  This will be of value
once the ISDN drivers are converted to the ISA/PCI/PNP hotplug APIs.

Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
2008-04-20 18:22:31 -04:00

298 lines
8.2 KiB
C

/* $Id: nj_s.c,v 2.13.2.4 2004/01/16 01:53:48 keil Exp $
*
* This software may be used and distributed according to the terms
* of the GNU General Public License, incorporated herein by reference.
*
*/
#include <linux/init.h>
#include "hisax.h"
#include "isac.h"
#include "isdnl1.h"
#include <linux/pci.h>
#include <linux/interrupt.h>
#include <linux/ppp_defs.h>
#include "netjet.h"
static const char *NETjet_S_revision = "$Revision: 2.13.2.4 $";
static u_char dummyrr(struct IsdnCardState *cs, int chan, u_char off)
{
return(5);
}
static void dummywr(struct IsdnCardState *cs, int chan, u_char off, u_char value)
{
}
static irqreturn_t
netjet_s_interrupt(int intno, void *dev_id)
{
struct IsdnCardState *cs = dev_id;
u_char val, s1val, s0val;
u_long flags;
spin_lock_irqsave(&cs->lock, flags);
s1val = bytein(cs->hw.njet.base + NETJET_IRQSTAT1);
if (!(s1val & NETJET_ISACIRQ)) {
val = NETjet_ReadIC(cs, ISAC_ISTA);
if (cs->debug & L1_DEB_ISAC)
debugl1(cs, "tiger: i1 %x %x", s1val, val);
if (val) {
isac_interrupt(cs, val);
NETjet_WriteIC(cs, ISAC_MASK, 0xFF);
NETjet_WriteIC(cs, ISAC_MASK, 0x0);
}
s1val = 1;
} else
s1val = 0;
/*
* read/write stat0 is better, because lower IRQ rate
* Note the IRQ is on for 125 us if a condition match
* thats long on modern CPU and so the IRQ is reentered
* all the time.
*/
s0val = bytein(cs->hw.njet.base + NETJET_IRQSTAT0);
if ((s0val | s1val)==0) { // shared IRQ
spin_unlock_irqrestore(&cs->lock, flags);
return IRQ_NONE;
}
if (s0val)
byteout(cs->hw.njet.base + NETJET_IRQSTAT0, s0val);
/* start new code 13/07/00 GE */
/* set bits in sval to indicate which page is free */
if (inl(cs->hw.njet.base + NETJET_DMA_WRITE_ADR) <
inl(cs->hw.njet.base + NETJET_DMA_WRITE_IRQ))
/* the 2nd write page is free */
s0val = 0x08;
else /* the 1st write page is free */
s0val = 0x04;
if (inl(cs->hw.njet.base + NETJET_DMA_READ_ADR) <
inl(cs->hw.njet.base + NETJET_DMA_READ_IRQ))
/* the 2nd read page is free */
s0val |= 0x02;
else /* the 1st read page is free */
s0val |= 0x01;
if (s0val != cs->hw.njet.last_is0) /* we have a DMA interrupt */
{
if (test_and_set_bit(FLG_LOCK_ATOMIC, &cs->HW_Flags)) {
printk(KERN_WARNING "nj LOCK_ATOMIC s0val %x->%x\n",
cs->hw.njet.last_is0, s0val);
spin_unlock_irqrestore(&cs->lock, flags);
return IRQ_HANDLED;
}
cs->hw.njet.irqstat0 = s0val;
if ((cs->hw.njet.irqstat0 & NETJET_IRQM0_READ) !=
(cs->hw.njet.last_is0 & NETJET_IRQM0_READ))
/* we have a read dma int */
read_tiger(cs);
if ((cs->hw.njet.irqstat0 & NETJET_IRQM0_WRITE) !=
(cs->hw.njet.last_is0 & NETJET_IRQM0_WRITE))
/* we have a write dma int */
write_tiger(cs);
/* end new code 13/07/00 GE */
test_and_clear_bit(FLG_LOCK_ATOMIC, &cs->HW_Flags);
}
spin_unlock_irqrestore(&cs->lock, flags);
return IRQ_HANDLED;
}
static void
reset_netjet_s(struct IsdnCardState *cs)
{
cs->hw.njet.ctrl_reg = 0xff; /* Reset On */
byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg);
mdelay(10);
/* now edge triggered for TJ320 GE 13/07/00 */
/* see comment in IRQ function */
if (cs->subtyp) /* TJ320 */
cs->hw.njet.ctrl_reg = 0x40; /* Reset Off and status read clear */
else
cs->hw.njet.ctrl_reg = 0x00; /* Reset Off and status read clear */
byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg);
mdelay(10);
cs->hw.njet.auxd = 0;
cs->hw.njet.dmactrl = 0;
byteout(cs->hw.njet.base + NETJET_AUXCTRL, ~NETJET_ISACIRQ);
byteout(cs->hw.njet.base + NETJET_IRQMASK1, NETJET_ISACIRQ);
byteout(cs->hw.njet.auxa, cs->hw.njet.auxd);
}
static int
NETjet_S_card_msg(struct IsdnCardState *cs, int mt, void *arg)
{
u_long flags;
switch (mt) {
case CARD_RESET:
spin_lock_irqsave(&cs->lock, flags);
reset_netjet_s(cs);
spin_unlock_irqrestore(&cs->lock, flags);
return(0);
case CARD_RELEASE:
release_io_netjet(cs);
return(0);
case CARD_INIT:
reset_netjet_s(cs);
inittiger(cs);
spin_lock_irqsave(&cs->lock, flags);
clear_pending_isac_ints(cs);
initisac(cs);
/* Reenable all IRQ */
cs->writeisac(cs, ISAC_MASK, 0);
spin_unlock_irqrestore(&cs->lock, flags);
return(0);
case CARD_TEST:
return(0);
}
return(0);
}
static int __devinit njs_pci_probe(struct pci_dev *dev_netjet,
struct IsdnCardState *cs)
{
u32 cfg;
if (pci_enable_device(dev_netjet))
return(0);
pci_set_master(dev_netjet);
cs->irq = dev_netjet->irq;
if (!cs->irq) {
printk(KERN_WARNING "NETjet-S: No IRQ for PCI card found\n");
return(0);
}
cs->hw.njet.base = pci_resource_start(dev_netjet, 0);
if (!cs->hw.njet.base) {
printk(KERN_WARNING "NETjet-S: No IO-Adr for PCI card found\n");
return(0);
}
/* the TJ300 and TJ320 must be detected, the IRQ handling is different
* unfortunatly the chips use the same device ID, but the TJ320 has
* the bit20 in status PCI cfg register set
*/
pci_read_config_dword(dev_netjet, 0x04, &cfg);
if (cfg & 0x00100000)
cs->subtyp = 1; /* TJ320 */
else
cs->subtyp = 0; /* TJ300 */
/* 2001/10/04 Christoph Ersfeld, Formula-n Europe AG www.formula-n.com */
if ((dev_netjet->subsystem_vendor == 0x55) &&
(dev_netjet->subsystem_device == 0x02)) {
printk(KERN_WARNING "Netjet: You tried to load this driver with an incompatible TigerJet-card\n");
printk(KERN_WARNING "Use type=41 for Formula-n enter:now ISDN PCI and compatible\n");
return(0);
}
/* end new code */
return(1);
}
static int __devinit njs_cs_init(struct IsdnCard *card,
struct IsdnCardState *cs)
{
cs->hw.njet.auxa = cs->hw.njet.base + NETJET_AUXDATA;
cs->hw.njet.isac = cs->hw.njet.base | NETJET_ISAC_OFF;
cs->hw.njet.ctrl_reg = 0xff; /* Reset On */
byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg);
mdelay(10);
cs->hw.njet.ctrl_reg = 0x00; /* Reset Off and status read clear */
byteout(cs->hw.njet.base + NETJET_CTRL, cs->hw.njet.ctrl_reg);
mdelay(10);
cs->hw.njet.auxd = 0xC0;
cs->hw.njet.dmactrl = 0;
byteout(cs->hw.njet.base + NETJET_AUXCTRL, ~NETJET_ISACIRQ);
byteout(cs->hw.njet.base + NETJET_IRQMASK1, NETJET_ISACIRQ);
byteout(cs->hw.njet.auxa, cs->hw.njet.auxd);
switch ( ( ( NETjet_ReadIC( cs, ISAC_RBCH ) >> 5 ) & 3 ) )
{
case 0 :
return 1; /* end loop */
case 3 :
printk( KERN_WARNING "NETjet-S: NETspider-U PCI card found\n" );
return -1; /* continue looping */
default :
printk( KERN_WARNING "NETjet-S: No PCI card found\n" );
return 0; /* end loop & function */
}
return 1; /* end loop */
}
static int __devinit njs_cs_init_rest(struct IsdnCard *card,
struct IsdnCardState *cs)
{
const int bytecnt = 256;
printk(KERN_INFO
"NETjet-S: %s card configured at %#lx IRQ %d\n",
cs->subtyp ? "TJ320" : "TJ300", cs->hw.njet.base, cs->irq);
if (!request_region(cs->hw.njet.base, bytecnt, "netjet-s isdn")) {
printk(KERN_WARNING
"HiSax: NETjet-S config port %#lx-%#lx already in use\n",
cs->hw.njet.base,
cs->hw.njet.base + bytecnt);
return (0);
}
cs->readisac = &NETjet_ReadIC;
cs->writeisac = &NETjet_WriteIC;
cs->readisacfifo = &NETjet_ReadICfifo;
cs->writeisacfifo = &NETjet_WriteICfifo;
cs->BC_Read_Reg = &dummyrr;
cs->BC_Write_Reg = &dummywr;
cs->BC_Send_Data = &netjet_fill_dma;
setup_isac(cs);
cs->cardmsg = &NETjet_S_card_msg;
cs->irq_func = &netjet_s_interrupt;
cs->irq_flags |= IRQF_SHARED;
ISACVersion(cs, "NETjet-S:");
return (1);
}
static struct pci_dev *dev_netjet __devinitdata = NULL;
int __devinit
setup_netjet_s(struct IsdnCard *card)
{
int ret;
struct IsdnCardState *cs = card->cs;
char tmp[64];
#ifdef __BIG_ENDIAN
#error "not running on big endian machines now"
#endif
strcpy(tmp, NETjet_S_revision);
printk(KERN_INFO "HiSax: Traverse Tech. NETjet-S driver Rev. %s\n", HiSax_getrev(tmp));
if (cs->typ != ISDN_CTYPE_NETJET_S)
return(0);
test_and_clear_bit(FLG_LOCK_ATOMIC, &cs->HW_Flags);
for ( ;; )
{
if ((dev_netjet = pci_find_device(PCI_VENDOR_ID_TIGERJET,
PCI_DEVICE_ID_TIGERJET_300, dev_netjet))) {
ret = njs_pci_probe(dev_netjet, cs);
if (!ret)
return(0);
} else {
printk(KERN_WARNING "NETjet-S: No PCI card found\n");
return(0);
}
ret = njs_cs_init(card, cs);
if (!ret)
return(0);
if (ret > 0)
break;
/* otherwise, ret < 0, continue looping */
}
return njs_cs_init_rest(card, cs);
}