1353aa5385
An Embedded Host High-Speed Electrical Test (EHSET) test fixture is used to initiate test modes on a host controller in order to perform the high speed electrical testing procedure for USB-IF compliance. When this test fixture is connected to a host, it can enumerate as one of several selectable VID/PID pairs, each corresponding to one of the following test modes: * TEST_SE0_NAK * TEST_J * TEST_K * TEST_PACKET * HS_HOST_PORT_SUSPEND_RESUME * SINGLE_STEP_GET_DEV_DESC * SINGLE_STEP_SET_FEATURE The USB EHSET procedure can be found here: http://www.usb.org/developers/onthego/EHSET_v1.01.pdf Signed-off-by: Manu Gautam <mgautam@codeaurora.org> [jackp@codeaurora.org: imported from commit 073c9409 on codeaurora.org; minor cleanup and updated author email] Signed-off-by: Jack Pham <jackp@codeaurora.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
29 lines
1.1 KiB
Makefile
29 lines
1.1 KiB
Makefile
#
|
|
# Makefile for the rest of the USB drivers
|
|
# (the ones that don't fit into any other categories)
|
|
#
|
|
obj-$(CONFIG_USB_ADUTUX) += adutux.o
|
|
obj-$(CONFIG_USB_APPLEDISPLAY) += appledisplay.o
|
|
obj-$(CONFIG_USB_CYPRESS_CY7C63) += cypress_cy7c63.o
|
|
obj-$(CONFIG_USB_CYTHERM) += cytherm.o
|
|
obj-$(CONFIG_USB_EMI26) += emi26.o
|
|
obj-$(CONFIG_USB_EMI62) += emi62.o
|
|
obj-$(CONFIG_USB_EZUSB_FX2) += ezusb.o
|
|
obj-$(CONFIG_USB_FTDI_ELAN) += ftdi-elan.o
|
|
obj-$(CONFIG_USB_IDMOUSE) += idmouse.o
|
|
obj-$(CONFIG_USB_IOWARRIOR) += iowarrior.o
|
|
obj-$(CONFIG_USB_ISIGHTFW) += isight_firmware.o
|
|
obj-$(CONFIG_USB_LCD) += usblcd.o
|
|
obj-$(CONFIG_USB_LD) += ldusb.o
|
|
obj-$(CONFIG_USB_LED) += usbled.o
|
|
obj-$(CONFIG_USB_LEGOTOWER) += legousbtower.o
|
|
obj-$(CONFIG_USB_RIO500) += rio500.o
|
|
obj-$(CONFIG_USB_TEST) += usbtest.o
|
|
obj-$(CONFIG_USB_EHSET_TEST_FIXTURE) += ehset.o
|
|
obj-$(CONFIG_USB_TRANCEVIBRATOR) += trancevibrator.o
|
|
obj-$(CONFIG_USB_USS720) += uss720.o
|
|
obj-$(CONFIG_USB_SEVSEG) += usbsevseg.o
|
|
obj-$(CONFIG_USB_YUREX) += yurex.o
|
|
obj-$(CONFIG_USB_HSIC_USB3503) += usb3503.o
|
|
|
|
obj-$(CONFIG_USB_SISUSBVGA) += sisusbvga/
|