85f2bf9f60
Implement MSI support via RTAS (RTAS = run-time firmware on pSeries machines). For now we assumes that if the required RTAS tokens for MSI are present, then we want to use the RTAS MSI routines. When RTAS is managing MSIs for us, it will/may enable MSI on devices that support it by default. This is contrary to the Linux model where a device is in LSI mode until the driver requests MSIs. To remedy this we add a pci_irq_fixup call, which disables MSI if they've been assigned by firmware and the device also supports LSI. Devices that don't support LSI at all will be left as is, drivers are still expected to call pci_enable_msi() before using the device. At the moment there is no pci_irq_fixup on pSeries, so we can just set it unconditionally. If other platforms use the RTAS MSI backend they'll need to check that still holds. Signed-off-by: Michael Ellerman <michael@ellerman.id.au> Signed-off-by: Paul Mackerras <paulus@samba.org>
20 lines
597 B
Makefile
20 lines
597 B
Makefile
ifeq ($(CONFIG_PPC64),y)
|
|
EXTRA_CFLAGS += -mno-minimal-toc
|
|
endif
|
|
|
|
obj-y := lpar.o hvCall.o nvram.o reconfig.o \
|
|
setup.o iommu.o ras.o rtasd.o \
|
|
firmware.o power.o
|
|
obj-$(CONFIG_SMP) += smp.o
|
|
obj-$(CONFIG_XICS) += xics.o
|
|
obj-$(CONFIG_SCANLOG) += scanlog.o
|
|
obj-$(CONFIG_EEH) += eeh.o eeh_cache.o eeh_driver.o eeh_event.o
|
|
obj-$(CONFIG_KEXEC) += kexec.o
|
|
obj-$(CONFIG_PCI) += pci.o pci_dlpar.o
|
|
obj-$(CONFIG_PCI_MSI) += msi.o
|
|
|
|
obj-$(CONFIG_HOTPLUG_CPU) += hotplug-cpu.o
|
|
|
|
obj-$(CONFIG_HVC_CONSOLE) += hvconsole.o
|
|
obj-$(CONFIG_HVCS) += hvcserver.o
|
|
obj-$(CONFIG_HCALL_STATS) += hvCall_inst.o
|