kernel-fxtec-pro1x/include/linux/platform_data/atmel.h
Jean-Christophe PLAGNIOL-VILLARD 3dcb7ea137 mtd/atmel_nand: add on_flash_bbt to enable the use of On Flash BBT
This will allow to enable it from the board.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: David Woodhouse <dwmw2@infradead.org>
2012-03-15 23:27:21 +08:00

27 lines
654 B
C

/*
* atmel platform data
*
* GPL v2 Only
*/
#ifndef __ATMEL_NAND_H__
#define __ATMEL_NAND_H__
#include <linux/mtd/nand.h>
/* NAND / SmartMedia */
struct atmel_nand_data {
int enable_pin; /* chip enable */
int det_pin; /* card detect */
int rdy_pin; /* ready/busy */
u8 rdy_pin_active_low; /* rdy_pin value is inverted */
u8 ale; /* address line number connected to ALE */
u8 cle; /* address line number connected to CLE */
u8 bus_width_16; /* buswidth is 16 bit */
u8 ecc_mode; /* ecc mode */
u8 on_flash_bbt; /* bbt on flash */
struct mtd_partition *parts;
unsigned int num_parts;
};
#endif /* __ATMEL_NAND_H__ */