Yoni Divinsky 4a6c789b73 wl12xx: set the irq polarity before loading the fw ... The polarity should be set before the firmware is loaded since the firmware touches the same register. Access of the firmware and driver to the same register will cause a collision since there is no exclusion scheme. Signed-off-by: Yoni Divinsky <yoni.divinsky@ti.com> Signed-off-by: Luciano Coelho <coelho@ti.com>		2012-06-05 20:24:31 +03:00
..
acx.c	wlcore/wl12xx: add hw_init operation	2012-04-12 08:44:00 +03:00
acx.h	wl12xx: implement fw status debugfs entries	2012-06-05 15:58:12 +03:00
cmd.c	wlcore/wl12xx: move ref_clock and tcxo_clock elements to wl12xx	2012-06-05 15:56:15 +03:00
cmd.h	wlcore/wl12xx: move extended radio configuration parameters to wl12xx	2012-04-12 08:44:01 +03:00
conf.h	wlcore/wl12xx: use a single memory config and reset if using wl127x	2012-04-12 08:44:01 +03:00
debugfs.c	wlcore/wl12xx/wl18xx: move lower driver debugfs to a subdir	2012-06-05 15:58:59 +03:00
debugfs.h	wl12xx: implement fw status debugfs entries	2012-06-05 15:58:12 +03:00
Kconfig	wireless: TI wlxxx depends on MAC80211	2012-05-15 17:53:24 -04:00
main.c	wl12xx: set the irq polarity before loading the fw	2012-06-05 20:24:31 +03:00
Makefile	wl12xx: implement fw status debugfs entries	2012-06-05 15:58:12 +03:00
reg.h	wlcore/wl12xx: add command trigger and event ack operations	2012-04-12 08:43:57 +03:00
wl12xx.h	wlcore/wl12xx: move rx_mem_pool_addr element to wl12xx	2012-06-05 15:56:22 +03:00