f15cbe6f1a
This follows the sparc changes a439fe51a1.
Most of the moving about was done with Sam's directions at:
http://marc.info/?l=linux-sh&m=121724823706062&w=2
with subsequent hacking and fixups entirely my fault.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
197 lines
5.6 KiB
C
197 lines
5.6 KiB
C
/*
|
|
* sh7760fb.h -- platform data for SH7760/SH7763 LCDC framebuffer driver.
|
|
*
|
|
* (c) 2006-2008 MSC Vertriebsges.m.b.H.,
|
|
* Manuel Lauss <mano@roarinelk.homelinux.net>
|
|
* (c) 2008 Nobuhiro Iwamatsu <iwamatsu.nobuhiro@renesas.com>
|
|
*/
|
|
|
|
#ifndef _ASM_SH_SH7760FB_H
|
|
#define _ASM_SH_SH7760FB_H
|
|
|
|
/*
|
|
* some bits of the colormap registers should be written as zero.
|
|
* create a mask for that.
|
|
*/
|
|
#define SH7760FB_PALETTE_MASK 0x00f8fcf8
|
|
|
|
/* The LCDC dma engine always sets bits 27-26 to 1: this is Area3 */
|
|
#define SH7760FB_DMA_MASK 0x0C000000
|
|
|
|
/* palette */
|
|
#define LDPR(x) (((x) << 2))
|
|
|
|
/* framebuffer registers and bits */
|
|
#define LDICKR 0x400
|
|
#define LDMTR 0x402
|
|
/* see sh7760fb.h for LDMTR bits */
|
|
#define LDDFR 0x404
|
|
#define LDDFR_PABD (1 << 8)
|
|
#define LDDFR_COLOR_MASK 0x7F
|
|
#define LDSMR 0x406
|
|
#define LDSMR_ROT (1 << 13)
|
|
#define LDSARU 0x408
|
|
#define LDSARL 0x40c
|
|
#define LDLAOR 0x410
|
|
#define LDPALCR 0x412
|
|
#define LDPALCR_PALS (1 << 4)
|
|
#define LDPALCR_PALEN (1 << 0)
|
|
#define LDHCNR 0x414
|
|
#define LDHSYNR 0x416
|
|
#define LDVDLNR 0x418
|
|
#define LDVTLNR 0x41a
|
|
#define LDVSYNR 0x41c
|
|
#define LDACLNR 0x41e
|
|
#define LDINTR 0x420
|
|
#define LDPMMR 0x424
|
|
#define LDPSPR 0x426
|
|
#define LDCNTR 0x428
|
|
#define LDCNTR_DON (1 << 0)
|
|
#define LDCNTR_DON2 (1 << 4)
|
|
|
|
#ifdef CONFIG_CPU_SUBTYPE_SH7763
|
|
# define LDLIRNR 0x440
|
|
/* LDINTR bit */
|
|
# define LDINTR_MINTEN (1 << 15)
|
|
# define LDINTR_FINTEN (1 << 14)
|
|
# define LDINTR_VSINTEN (1 << 13)
|
|
# define LDINTR_VEINTEN (1 << 12)
|
|
# define LDINTR_MINTS (1 << 11)
|
|
# define LDINTR_FINTS (1 << 10)
|
|
# define LDINTR_VSINTS (1 << 9)
|
|
# define LDINTR_VEINTS (1 << 8)
|
|
# define VINT_START (LDINTR_VSINTEN)
|
|
# define VINT_CHECK (LDINTR_VSINTS)
|
|
#else
|
|
/* LDINTR bit */
|
|
# define LDINTR_VINTSEL (1 << 12)
|
|
# define LDINTR_VINTE (1 << 8)
|
|
# define LDINTR_VINTS (1 << 0)
|
|
# define VINT_START (LDINTR_VINTSEL)
|
|
# define VINT_CHECK (LDINTR_VINTS)
|
|
#endif
|
|
|
|
/* HSYNC polarity inversion */
|
|
#define LDMTR_FLMPOL (1 << 15)
|
|
|
|
/* VSYNC polarity inversion */
|
|
#define LDMTR_CL1POL (1 << 14)
|
|
|
|
/* DISPLAY-ENABLE polarity inversion */
|
|
#define LDMTR_DISPEN_LOWACT (1 << 13)
|
|
|
|
/* DISPLAY DATA BUS polarity inversion */
|
|
#define LDMTR_DPOL_LOWACT (1 << 12)
|
|
|
|
/* AC modulation signal enable */
|
|
#define LDMTR_MCNT (1 << 10)
|
|
|
|
/* Disable output of HSYNC during VSYNC period */
|
|
#define LDMTR_CL1CNT (1 << 9)
|
|
|
|
/* Disable output of VSYNC during VSYNC period */
|
|
#define LDMTR_CL2CNT (1 << 8)
|
|
|
|
/* Display types supported by the LCDC */
|
|
#define LDMTR_STN_MONO_4 0x00
|
|
#define LDMTR_STN_MONO_8 0x01
|
|
#define LDMTR_STN_COLOR_4 0x08
|
|
#define LDMTR_STN_COLOR_8 0x09
|
|
#define LDMTR_STN_COLOR_12 0x0A
|
|
#define LDMTR_STN_COLOR_16 0x0B
|
|
#define LDMTR_DSTN_MONO_8 0x11
|
|
#define LDMTR_DSTN_MONO_16 0x13
|
|
#define LDMTR_DSTN_COLOR_8 0x19
|
|
#define LDMTR_DSTN_COLOR_12 0x1A
|
|
#define LDMTR_DSTN_COLOR_16 0x1B
|
|
#define LDMTR_TFT_COLOR_16 0x2B
|
|
|
|
/* framebuffer color layout */
|
|
#define LDDFR_1BPP_MONO 0x00
|
|
#define LDDFR_2BPP_MONO 0x01
|
|
#define LDDFR_4BPP_MONO 0x02
|
|
#define LDDFR_6BPP_MONO 0x04
|
|
#define LDDFR_4BPP 0x0A
|
|
#define LDDFR_8BPP 0x0C
|
|
#define LDDFR_16BPP_RGB555 0x1D
|
|
#define LDDFR_16BPP_RGB565 0x2D
|
|
|
|
/* LCDC Pixclock sources */
|
|
#define LCDC_CLKSRC_BUSCLOCK 0
|
|
#define LCDC_CLKSRC_PERIPHERAL 1
|
|
#define LCDC_CLKSRC_EXTERNAL 2
|
|
|
|
#define LDICKR_CLKSRC(x) \
|
|
(((x) & 3) << 12)
|
|
|
|
/* LCDC pixclock input divider. Set to 1 at a minimum! */
|
|
#define LDICKR_CLKDIV(x) \
|
|
((x) & 0x1f)
|
|
|
|
struct sh7760fb_platdata {
|
|
|
|
/* Set this member to a valid fb_videmode for the display you
|
|
* wish to use. The following members must be initialized:
|
|
* xres, yres, hsync_len, vsync_len, sync,
|
|
* {left,right,upper,lower}_margin.
|
|
* The driver uses the above members to calculate register values
|
|
* and memory requirements. Other members are ignored but may
|
|
* be used by other framebuffer layer components.
|
|
*/
|
|
struct fb_videomode *def_mode;
|
|
|
|
/* LDMTR includes display type and signal polarity. The
|
|
* HSYNC/VSYNC polarities are derived from the fb_var_screeninfo
|
|
* data above; however the polarities of the following signals
|
|
* must be encoded in the ldmtr member:
|
|
* Display Enable signal (default high-active) DISPEN_LOWACT
|
|
* Display Data signals (default high-active) DPOL_LOWACT
|
|
* AC Modulation signal (default off) MCNT
|
|
* Hsync-During-Vsync suppression (default off) CL1CNT
|
|
* Vsync-during-vsync suppression (default off) CL2CNT
|
|
* NOTE: also set a display type!
|
|
* (one of LDMTR_{STN,DSTN,TFT}_{MONO,COLOR}_{4,8,12,16})
|
|
*/
|
|
u16 ldmtr;
|
|
|
|
/* LDDFR controls framebuffer image format (depth, organization)
|
|
* Use ONE of the LDDFR_?BPP_* macros!
|
|
*/
|
|
u16 lddfr;
|
|
|
|
/* LDPMMR and LDPSPR control the timing of the power signals
|
|
* for the display. Please read the SH7760 Hardware Manual,
|
|
* Chapters 30.3.17, 30.3.18 and 30.4.6!
|
|
*/
|
|
u16 ldpmmr;
|
|
u16 ldpspr;
|
|
|
|
/* LDACLNR contains the line numbers after which the AC modulation
|
|
* signal is to toggle. Set to ZERO for TFTs or displays which
|
|
* do not need it. (Chapter 30.3.15 in SH7760 Hardware Manual).
|
|
*/
|
|
u16 ldaclnr;
|
|
|
|
/* LDICKR contains information on pixelclock source and config.
|
|
* Please use the LDICKR_CLKSRC() and LDICKR_CLKDIV() macros.
|
|
* minimal value for CLKDIV() must be 1!.
|
|
*/
|
|
u16 ldickr;
|
|
|
|
/* set this member to 1 if you wish to use the LCDC's hardware
|
|
* rotation function. This is limited to displays <= 320x200
|
|
* pixels resolution!
|
|
*/
|
|
int rotate; /* set to 1 to rotate 90 CCW */
|
|
|
|
/* set this to 1 to suppress vsync irq use. */
|
|
int novsync;
|
|
|
|
/* blanking hook for platform. Set this if your platform can do
|
|
* more than the LCDC in terms of blanking (e.g. disable clock
|
|
* generator / backlight power supply / etc.
|
|
*/
|
|
void (*blank) (int);
|
|
};
|
|
|
|
#endif /* _ASM_SH_SH7760FB_H */
|