Merge remote-tracking branches 'spi/fix/pxa2xx', 'spi/fix/qup' and 'spi/fix/sh-sci' into spi-linus

This commit is contained in:
Mark Brown 2014-06-28 14:01:23 +01:00
commit 7216a41839
4 changed files with 27 additions and 35 deletions

View file

@ -23,6 +23,12 @@ Optional properties:
- spi-max-frequency: Specifies maximum SPI clock frequency,
Units - Hz. Definition as per
Documentation/devicetree/bindings/spi/spi-bus.txt
- num-cs: total number of chipselects
- cs-gpios: should specify GPIOs used for chipselects.
The gpios will be referred to as reg = <index> in the SPI child
nodes. If unspecified, a single SPI device without a chip
select can be used.
SPI slave nodes must be children of the SPI master node and can contain
properties described in Documentation/devicetree/bindings/spi/spi-bus.txt

View file

@ -118,6 +118,7 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
*/
orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
/* Test SPI_CS_CONTROL_SW_MODE bit enabling */
value = orig | SPI_CS_CONTROL_SW_MODE;
writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
@ -126,10 +127,13 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
goto detection_done;
}
value &= ~SPI_CS_CONTROL_SW_MODE;
orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
/* Test SPI_CS_CONTROL_SW_MODE bit disabling */
value = orig & ~SPI_CS_CONTROL_SW_MODE;
writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
if (value != orig) {
if (value != (orig & ~SPI_CS_CONTROL_SW_MODE)) {
offset = 0x800;
goto detection_done;
}

View file

@ -424,31 +424,6 @@ static int spi_qup_io_config(struct spi_device *spi, struct spi_transfer *xfer)
return 0;
}
static void spi_qup_set_cs(struct spi_device *spi, bool enable)
{
struct spi_qup *controller = spi_master_get_devdata(spi->master);
u32 iocontol, mask;
iocontol = readl_relaxed(controller->base + SPI_IO_CONTROL);
/* Disable auto CS toggle and use manual */
iocontol &= ~SPI_IO_C_MX_CS_MODE;
iocontol |= SPI_IO_C_FORCE_CS;
iocontol &= ~SPI_IO_C_CS_SELECT_MASK;
iocontol |= SPI_IO_C_CS_SELECT(spi->chip_select);
mask = SPI_IO_C_CS_N_POLARITY_0 << spi->chip_select;
if (enable)
iocontol |= mask;
else
iocontol &= ~mask;
writel_relaxed(iocontol, controller->base + SPI_IO_CONTROL);
}
static int spi_qup_transfer_one(struct spi_master *master,
struct spi_device *spi,
struct spi_transfer *xfer)
@ -571,12 +546,16 @@ static int spi_qup_probe(struct platform_device *pdev)
return -ENOMEM;
}
/* use num-cs unless not present or out of range */
if (of_property_read_u16(dev->of_node, "num-cs",
&master->num_chipselect) ||
(master->num_chipselect > SPI_NUM_CHIPSELECTS))
master->num_chipselect = SPI_NUM_CHIPSELECTS;
master->bus_num = pdev->id;
master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH | SPI_LOOP;
master->num_chipselect = SPI_NUM_CHIPSELECTS;
master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 32);
master->max_speed_hz = max_freq;
master->set_cs = spi_qup_set_cs;
master->transfer_one = spi_qup_transfer_one;
master->dev.of_node = pdev->dev.of_node;
master->auto_runtime_pm = true;
@ -640,16 +619,19 @@ static int spi_qup_probe(struct platform_device *pdev)
if (ret)
goto error;
ret = devm_spi_register_master(dev, master);
if (ret)
goto error;
pm_runtime_set_autosuspend_delay(dev, MSEC_PER_SEC);
pm_runtime_use_autosuspend(dev);
pm_runtime_set_active(dev);
pm_runtime_enable(dev);
ret = devm_spi_register_master(dev, master);
if (ret)
goto disable_pm;
return 0;
disable_pm:
pm_runtime_disable(&pdev->dev);
error:
clk_disable_unprepare(cclk);
clk_disable_unprepare(iclk);

View file

@ -175,9 +175,9 @@ static int sh_sci_spi_remove(struct platform_device *dev)
{
struct sh_sci_spi *sp = platform_get_drvdata(dev);
iounmap(sp->membase);
setbits(sp, PIN_INIT, 0);
spi_bitbang_stop(&sp->bitbang);
setbits(sp, PIN_INIT, 0);
iounmap(sp->membase);
spi_master_put(sp->bitbang.master);
return 0;
}