kernel-fxtec-pro1x/drivers/net/enic/Makefile

obj-$(CONFIG_ENIC) := enic.o

enic-y := enic_main.o vnic_cq.o vnic_intr.o vnic_wq.o \
	enic_res.o vnic_dev.o vnic_rq.o vnic_vic.o
enic: add Cisco 10G Ethernet NIC driver Signed-off-by: Scott Feldman <scofeldm@cisco.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com> 2008-09-15 10:17:11 -06:00			`obj-$(CONFIG_ENIC) := enic.o`

			`enic-y := enic_main.o vnic_cq.o vnic_intr.o vnic_wq.o \`
net: Add ndo_{set\|get}_vf_port support for enic dynamic vnics Add enic ndo_{set\|get}_vf_port ops to support setting/getting port-profile for enic dynamic devices. Enic dynamic devices are just like normal enic eth devices except dynamic enics require an extra configuration step to assign a port-profile identifier to the interface before the interface is useable. Once a port-profile is assigned, link comes up on the interface and is ready for I/O. The port-profile is used to configure the network port assigned to the interface. The network port configuration includes VLAN membership, QoS policies, and port security settings typical of a data center network. A dynamic enic initially has a zero-mac address. Before a port-profile is assigned, a valid non-zero unicast mac address should be assign to the dynamic enic interface. Signed-off-by: Scott Feldman <scofeldm@cisco.com> Signed-off-by: Roopa Prabhu <roprabhu@cisco.com> 2010-05-17 23:50:19 -06:00			`enic_res.o vnic_dev.o vnic_rq.o vnic_vic.o`
enic: add Cisco 10G Ethernet NIC driver Signed-off-by: Scott Feldman <scofeldm@cisco.com> Signed-off-by: Jeff Garzik <jgarzik@redhat.com> 2008-09-15 10:17:11 -06:00